![]() # Bus 002 Device 002: ID 05f3:00ff PI Engineering, Inc. # Set permissions for USB footpedal Infinity IN-USB-1 Finally, after I got permissions issues (the error message suggested I run sudo chmod a+r /dev/usb/hiddev0 footpedal, which didn’t seem to work) I followed Jason Barnett’s and Richard Steffan’s advice and set up a udev rule:.I edited the script following Phillip Goodfellow’s instructions.Ī finding the script: # which footpedal -> /usr/bin/footpedalī editing that script to comment out lines 119-126:ġ19 # Check whether your notification agent supportġ25 # self.reusable_t_timeout(1000) After installation, the script didn’t work immediately.This will not work with the free version. This will enable the device to control the software. then click next makes sure it shows the 'VEC Infinity In-USB-1 / In-USB-2 (USB) as the 'Plug and Play' Then click 'Next' twice and after that 'Finish'. First, I installed the lovely Footpedal GNOME integration control, which sadly seems a bit dormant. Make sure that 'Enable foot control' is checked.Getting the foot pedal working in Linux (Mint 14) was a minor mission, so I thought I’d document it for anyone else doing the same: However, this set-up did have some Rachmaninoff problems – requiring hand contortion to control audio, with attendant RSI/CTS-baiting effects that often resulted in sore wrists during transcription binges. ![]() It does make a tremendous difference not to have to constantly move one’s fingers from keyboard to mouse and back, although I had mitigated this considerably by using a thinkpad external keyboard with a trackpoint. I picked this Infinity USB-2 pedal up from ebay for $30. John Heritage told me to go buy a foot pedal. It was written in 2013 so the software is *very* out of date and I doubt I’ll able to help you if it goes wrong. UPDATE 2: Please do not follow the instructions on this blog and expect them to work. It’s a great piece of software and well worth the modest price. Otherwise, you can also go into the Preferences -> Controller tab and run the foot pedal configuration tool.UPDATE: I have subsequently found that transcribe works beautifully well and comes with some great pedal drivers. The pedals should now be correctly installed.įor Mac OS X version of Express Scribe v5.40 and later - See the above instructions.įor Mac OS X version of Express Scribe 5 and earlier - just plug them into the USB socket and run Express Scribe and they will be detected normally. You can make it works with any software, you just need to set it up with the pedal control application.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |